USER MANUAL
SPEED DOME CAMERAS SD-xxx-5
Page:10
WWW.DSE.EU
System PRESET
Not all 255 camera presets are available for user customization; some presets are used by the camera for particular
functions and are called SYSTEM PRESET.
The system presets allow you to access the camera configuration and to quickly issue the main commands, such as
starting SCAN, CRUISE and PATTERN. The control consoles and DVRs also have buttons to start automatic movements,
but often, due to the imperfect standardization of the PELCO communication protocol, they may not be effective. The
use of system presets, on the other hand, always works on any type of control unit.
The cameras of this range allow many operations with the system presets, making the use of the OSD menu that we
will describe later unnecessary.
PRESET
COMMAND
FUNCTION
DESCRIPTION
GENERAL COMMANDS
34
CALL
Reset
Reboot the camera
81 (41)
CALL
Day / Night by car
Set Day / Night switching to automatic
82 (42)
CALL
Day / Night over night
Force night mode (B&W)
83
CALL
Day / Night on day
Force day mode (color)
84
CALL
IR max
Force maximum IR illumination
85
CALL
IR min
Force minimal IR illumination
ninety
two
CALL
Start AB scan
Start scanning between two limit switches (AB)
The continuous horizontal movement between 2 limit switch
limits with the same TILT level is defined as AB SCAN
94
CALL
Close OSD menu
Closes the overlay menu for camera configuration
95
CALL
Opens OSD menu
Activate the overlay menu for camera configuration
96
CALL
Start Tour 3
Start the tour 3
A TOUR is the sequential display of various presets.
97
CALL
Start Tour 2
Start tour 2
98 (38)
CALL
Start Tour 1
Start tour 1
99 (39)
CALL
Start 360 ° Scan
Start the 360 ° panoramic scan
COMMANDS FOR VIDEO SIGNAL SETTING
137
CALL
2 times
Set AHD video
Call the preset twice to set the video signal in AHD, used by
DSE DVR
138
CALL
2 times
Set up TVI video
Call the preset twice to set the TVI video signal, used by
HikVision DVR
139
CALL
2 times
Set up CVI video
Call the preset twice to set the CVI video signal, used by Dahua
DVR
140
CALL
2 times
Set up CVBS video
Call the preset twice to set the CVBS video signal, the standard
analog composite video
115
CALL
2 times
Set NTSC video
Call the preset twice to set the video signal in NTSC format
116
CALL
2 times
Set PAL video
Call the preset twice to set the video signal in PAL format
102
CALL
2 times
Opens room module
settings
The camera module contains some settings on the video signal
of the camera. In the camera menu, preset 102 is also called
up as the ENTER key
ATTENTION - Some of the system presets, like all the video setting commands, only work with the RS485 protocol and
cannot be used with UTC control on video cables.