DSE DSEGenset DSE8004, Руководство оператора

Страница: 75 / 80

Front Panel Configuration
75
8.2 ACCESSING THE DSE8XXX CONTROLLER RUNNING EDITOR
To enter the a DSE8xxx controller‘s running editor, ensure the System page is being viewed with the
DSE8xxx controller selected or one of the DSE8xxx controller’s instrument pages.
The press and hold the Tick button to enter.
NOTE: For further details on available parameters in a module’s Running Editor, refer to
their installation instructions. Refer to section entitled Bibliography elsewhere in the
document for a list of applicable installation instructions.
8.3 FRONT PANEL EDITOR ACCESS
To enter the a DSE8xxx controller‘s front panel editor, ensure the System page is being viewed with
the DSE8xxx controller selected or one of the DSE8xxx controller’s instrument pages.
A simultaneous press of the Stop/Reset Mode button and Tick button enters the front
panel editor.
A press and hold of the Tick button exits the FPE, with changes to the DSE8xxx controller
configuration file saved.
A press and hold of the Stop/Reset Mode will exit the FPE, without saving changes to the
DSE8xxx controller configuration file.
8.3.1 FRONT PANEL EDITOR SECURITY
If configured in the DSE8xxx controller, the user is required to enter a 4-digit pin number before
entering the front panel editor. # Symbols mask the digits of the pin number, unless being edited.
A press of the Tick button begins and ends the editing process.
The Instrumentation Scroll buttons modify a digit and
The Next & Previous Page buttons select them.
At the end of editing, as the Tick button is pressed, the pin is checked and access granted if
correct.