4
S e c t i o n 3 : E n ro l l i n g t h e
P C 5 5 0 2Z 2
Once you have completed all the keypad wiring, you will need to enter a 2-digit number
that tells the main control panel the slot assignment of the keypad.
The slot assignment tells the panel which keypad slots are occupied. The panel can then
generate a fault when a keypad supervisory signal is not present.
NOTE:
When the PC5502Z2 supervisory signal is lost, the system will not sound
an audible tamper, or a zone expander supervisory alarm unless the main panel
is armed.
There are eight available slots for keypads. PC5502Z2 keypads are always assigned to
slot 11 by default. You must assign each keypad to its own slot (11 to 18) for it to be
properly supervised by the system.
NOTE:
PC5502Z2 keypads should only be enrolled on partition 1.
To enroll the PC5502Z2:
1. At the PC5502Z2 keypad, enter [*][8][Installer’s Code]
2. Press [00] for Slot Assignment
3. Enter a two digit number to specify the slot assignment (11-18).
4. Press the [#] key twice to exit programming.
5. After you have assigned slots to all the keypads, go to the system keypad. Perform a
supervisory reset by entering section [902] in the main panel Installer’s programming.
The panel will now supervise all assigned keypads and enrolled modules on the sys-
tem.
Now that you have enrolled the PC5502Z2 on the system, you will need to program it.
Please see section 4 for instructions.
