1
This manual describes how to install, program and maintain the PC5102-433.
Before you install the PC5102-433 module, you should complete the following steps
in your system installation:
1. Plan the installation and wiring of the security system (see your system
Installation Manual
).
2. Install the control panel, and install and enroll at least one keypad to use for
programming.
Program the PC5102-433 from a system keypad or using DLS-3 v1.3 with the PC5102-
433 v1.0 Driver Pack. Read your system
Installation Manual
for more information.
1.1 How to Use this Manual
Read this manual before you begin installing the PC5102-433. To install and set up the
PC5102-433 and wireless keys, follow these steps. Refer to the sections listed below.
1. Temporarily mount and wire the PC5102-433 module (see
Section 2
).
2. Enroll and program wireless keys (see
Section 3
).
3. Complete PGM and other programming on the system (see
Section 4
).
4. Test the placement of all the wireless keys
(see Section 5).
5. Permanently mount the PC5102-433 receiver
(see Section 5).
For additional information on trouble conditions and battery replacement, see
Section 6.
For help with troubleshooting, see
Section 7.
1.2 Specifications and Features
• Current Draw: 50mA (standby) 200mA maximum (both outputs active)
• Frequency: 433 MHz
• Receiver can receive signals from up to 8 wireless keys
• Antenna - internal. Installation not required
• Location
- can be wired up to 750 ft/230m. from the main panel with 22 gauge wire
- connects to Keybus
- for longer wire runs, thicker gauge wire must be used
• Compatibility: The PC5102-433 v1.X can be connected to the following
panels:
PC501X, P832/DL, PC5020, P-8+, PC1555, P-6B, PC1555MX, P-6BMX,
PC580, P-48
S E C T I O N 1
Introduction