GS3125/GS3105
73
G
G
G
G
G
PLAY button - Press to listen to the voice message again.
RECORD button - Press to start recording a new voice message.
STOP button - Press to stop replaying or recording a voice message.
GET button - Press to load the recorded voice message.
SET button - Press to send the recorded voice message to the Communicator.
ERASE button - Press this button to erase the voice message on the Communicator.
When recording a message, a progress bar indicates (in real time) the time elapsed.
Local Voice Message Recording
You can connect ONLY ONE telephone to the [LI] terminals for proper working of the Local Voice Message Recording.
To record a voice message from a touchtone telephone connected to the [LI] terminals, enable the Local Service Mode in
the Voice Dialler section and proceed as follows:
1. Press the
button;
2. Press the
buttons in sequence to enter record mode;
3. Enter the number of the message you wish to record (between
and
);
4. After the beep, record your voice message (the maximum duration of the message is 16 seconds).
5. Press the
button to confirm message recording (or press the
button again if you wish to stop recording the message
before the full amount of time has elapsed); you will hear a boop tone.
At this moment, any previous recordings for this message will be DELETED;
6. If you need to record any other messages, repeat the procedure described in step 1.
Local Voice Message Replaying
You can connect ONLY ONE telephone to the [LI] terminals for proper working of the Local Voice Message Replaying.
To replay a voice message from a touchtone telephone connected to the [LI] terminals, enable the Local Service Mode in
the Voice Dialler section and proceed as follows:
1. Press the
button ;
2. Press the
buttons in sequence to enter replay mode;
3. Enter the number of the message you wish to replay (between
and
);
4. After the beep, the message will be replayed, followed by a confirmation boop tone (press the key
to stop the
message playing);
5. If you need to replay any other messages, repeat the procedure described in step 1.
Optional Tamper Programming
Through the connection (see section Connecting the device->Auxiliary connections) of MAXIASNC tamper switch
(optional) you can detect the Communicator cover opens. To send a SMS and/or voice message to one or more telephone
numbers when the Communicator cover is removed, perform the following setup, by means of the GS3100 Series Console.
1) In the Phonebook page, enter the telephone numbers for the tamper message.
2) In the I/O page, set the T3 terminal as Input (Type column) with NO (Normally Open) standby status (Polarity column):
the standby status of the tamper switch is Normally Closed.
3) In the SMS dialer and/or Voice dialer page set, for the Input 3 Event, the SMS and/or the Voice message, and the
required telephone numbers.
