5
HSPA(3G)/Dual Alarm Communicator Installation Manual
• Do NOT strip off cable sheathing more than required for proper termination.
• Do NOT kink/knot cable.
• Do NOT crush cable with cable ties.
• Do NOT untwist CAT5 pairs more than ½ in. (1.2cm).
• Do NOT splice cable.
• Do NOT bend cable at right angles or make any other sharp bends.
NOTE:
CAT5 specification requires that any cable bend must have a minimum 2 in. (5 cm) bend
radius. Maximum length of CAT 5 cable is 328 ft. (100 m).
Inserting and Removing the SIM Card
1. Remove the front cover of the panel to access SIM holder.
2. Remove power from the panel and disconnect the battery and telephone line.
3. On the SIM card holder push gently to slide the cover downwards to
OPEN
. This will unlatch
the SIM card holder on the top edge of the communicator PCB. (See
).
4. Tilt the top of the SIM card holder downwards to access the SIM card.
NOTE:
The SIM can be damaged by bending or scratching contacts. Use caution when handling
SIM cards.
5. Insert or remove the SIM card, noting the orientation of the notches on the SIM card and the
SIM card holder.
6. When inserting a SIM card, insert the card in the proper orientation and gently push the SIM
card holder down and slide the holder as indicated by the arrow on SIM holder, to
LOCK
.
7. Reconnect the backup battery and telephone line, apply AC power to panel, and replace the
panel cover.
Running the RS-422 Cable (R models only)
When installing the communicator for use with 3rd party applications an RS-422 cable must be
connected between the 3rd party device and the communicator module.
NOTE:
Maximum cable length for RS-422 cable is 1,000 ft. (305 m).
Please refer to the installation manual for the 3rd party device for wiring instructions.
Installing Communicator with HS2016, HS2032, HS2064, and
HS2128 Panel
NOTE:
Before installing communicator or inserting/removing SIM, ensure that system power is
OFF and telephone line is disconnected.
1. To assemble supplied mounting bracket, perform the following: (See
a. Remove the 4 white plastic
standoffs from the bag pro-
vided with the communica-
tor kit.
b. Insert the 4 standoffs through
the back of the mounting
bracket, into the holes at each
corner. (The antenna mount-
ing tab should be facing away
from you).
c. Place the bracket on a flat,
solid surface. Hold the com-
municator component side up
and orient the 4 holes on the
communicator with the 4
standoffs protruding from the
I
NSTALLING
C
OMMUNICATOR
IN
P
ANEL
DG0009744
Brass Washer
Nylon washer (flat)
Nylon Washer
with bushing
(thicker flat washer)
Brass nut
Antenna
Mounting Tab
Mounting
Holes
Mounting Holes
Antenna
Cable
Mounting Plate
External Antenna
Screw Thread
Communicator
Board
Mounting
Plate
Stand Off
Figure 1:Communicator Mounting Bracket
