Dru Excellence 60, Руководство по установке

Страница: 13 / 40

English
I NS TAL LAT ION M ANUA L
5.12 Setting the appliance
The appliance has to be set in such a way that it works correctly in combination with the concentric system.
For that purpose, it is possible to install a restrictor slide and/or remove the air inlet guide. The condition for
application with wall terminal and roof terminal are stated in Appendix 2, Tables 4, 5 and 6.
This appliance is suitable for PowerVent®. For more information, see the PowerVent® installation manual.
5.12.1 Air inlet guides
The air inlet guides are mounted on the left and right side on the burner mounting plate. In order to reach them,
you must remove the vermiculite tray. Ex factory, large air inlet guides are mounted. Use tables 4, 5 and 6 to
determine whether the large air inlet guides must be replaced by smaller versions.
If you want to remove them, proceed as follows (see Appendix 3, Fig. 9 to 11):
Ø
Unscrew the self-tapping screws from the decorative clamping plates (see Appendix 3, Fig. 9 (A)) and remove
them;
Ø
Remove the vermiculite tray (see Appendix 3, Fig. 10 (B));
Ø
Unscew the self-tapping screws of the left and right large air inlet guide (C);
Ø
Replace the large air inlet guides by the smaller versions (see Appendix 3, Fig. 11 (D));
Ø
Tighten the small air inlet guides (D) with the self-tapping screws;
Ø
Reinstall the vermiculite tray (B);
Ø
Re-tighten the decorative clamping plates (A) using the 4 self-tapping screws;
5.12.2 Restrictor slide
The restrictor slide (R) is supplied separtely (see Appendix 3, Fig. 12).
It is mounted as follows:
Ø
Unscrew the rear decorative clamp (top) (Q) and allow it to lower on the decorative plate.
Ø
Unscrew the self-tapping screws (S) of the middle plate (T) and remove it.
Ø
Unscrew the self-tapping screws from the guide plate (P) and remove it.
Ø
Install the restrictor slide (R).
Ø
Place back the guide plate (P) and fasten it with the self-tapping screws.
Ø
Adjust the distance of the restrictor.
- in case of a 20 mm setting, the restrictor slide is closed to a maximum level;
- in case of a 40 and 30 mm setting, you should use a gauge (see Appendix 3, Fig. 13).
Ø
Fix the restrictor slide in position with the allen screw (see Appendix 3, Fig. 12 (U)).
Ø
Place back the middle plate (T) and tighten it using the self-tapping screws (S).
Ø
Tighten the rear decorative clamp (top) (Q) onto the middle plate (T).
UK