OPERATING INSTRUCTIONS
Lighting
Press button A and turn to the left to the small flame
.
The flame will ignite at
. Check that the pilot is alight. If
that is the case, hold button A firmly pressed for another 5
seconds.Then release button A and check that the pilot
light is still burning. Now turn button A to the large
flame
, which will open the main valve of the control
block. Depending on the setting of the control button B,
high or low flames will be visible.
Remote Control
The height of the flames can be regulated by remote
control, which will turn button B (fig. 6) on the gas control
block. Press the bottom button on the remote control for
a smaller flame; press the upper button for a higher flame.
Manually adjusting button B will have the same effect. A
certain force is required when rotating button B, a clicking
sound is quite normal.
Pilot light setting
If the heater is not in use but you would like the pilot light
to remain alight, set button A to the small flame.The gas
supply to the main burner will then be switched off.
Switching off
Turn button A to the "0" setting.The gas supply to the
burners will then be switched off.
Important
A built-in safety lock is activated when the appliance is
switched to "OFF" (closed down setting).Therefore, wait 5
minutes before relighting the heater.Within this period, do
not try to push the lighting button, as this has been
blocked by the safety lock. Do not force the button, as this
may result in damage to the mechanism.
OPERATING INSTRUCTIONS
18
fig. 6
