20
The table below shows all the values that can be set from this menu.
NAME
FULL NAME
DEFAULT
VALUE
DESCRIPTION
VALUES/INTERVAL
Stores All logs
Stores all Logs
☐
Enabling the recording of all events (logs) relating
to pump status (Pause, lubrication, etc.)
Ticked
☐
Not ticked
Synchronize Date
Synchronize Date
Enabling synchronization of date/time from the
Internet
Ticked
☐
Not ticked
Save Screen
Save Screen
0s
Display-backlight deactivation time
0s-1,800s
Basic password
Basic password
0000
Password for accessing basic settings
0000-9999
Advanced password
Advanced password
0000
Password for accessing advanced settings
0000-9999
System password
System password
0000
System settings access password
0000-9999
Lock Screen
Lock Screen
1m
Period of time after which the password protection
in a menu is activated
30s
1m
10m
30m
60m
FW Update
Firmware update
-
Button for the firmware update request (Internet
connection required)
-
Reboot Device
Reboot Device
-
Device reboot button
-
Time zone
Time zone
+2H 00M
Time zone setting
-12H 00M ÷ +12H 00M
Device Info
Device Info
-
Pump general information display button
-
Current date
Current date
-
Setting of current date
-
Current time
Current time
-
Setting current time
00:00 – 23:59
Page Change
Page Change
No
Display
Setting of page change following an alarm and/or
warning
No Display
Only Alarms
Alarms and Warnings
Page Change
Duration
Page Change
Duration
10s
Duration of the page transition following an alarm
and/or warning
0s-10m
9.5
FIRST START-UP
Before beginning to program the pump, remember to fill the lubricant reservoir, following the instructions in section 7.2.1.
and proceed as follows:
1.
If there are signal connectors, they should be disconnected before switching on the pump;
2.
Connect the pump to the power supply and switch it on;
3.
When it starts, the main screen will appear (see 9.1.) in alarm status;
4.
Set the language (see section 9.2 ADVANCED SETTINGS)
5.
Depending on the lubrication system present, set the parameters referring to the OPERATING MODES section
(SECTION 9.4.2.1)
6.
Connect the previously prepared signal cables (if present)
