12
System Setup
Connect drain line to barbed drain adapter and run to appropriate discharge point. Use
a 1/2” minimum pipe size for the drain. Use a 3/4” drain line for runs that exceed 20 feet.
Make connection to a sanitary waste system through an air gap of 2 pipe diameters or
1”, larger. Do not tee into any other drain lines.
Discharge Options
STAND PIPE
LAUNDRY TUB
FLOOR DRAIN
BRINE LINE CONNECTION TO
CONTROL VALVE
BRINE LINE CONNECTION TO
BRINE TANK
Remove brass compression nut from the
softener control valve. Take brine tubing
(packaged with brine tank) and slide the
brass nut and plastic ferrule onto one end
of the tubing. Find the plastic tubing insert
(taped to the brine well cap inside the brine
tank) and insert it into the end of the tubing.
Next, insert the tubing into the control valve
and tighten the nut.
Inside the brine tank, remove the cap from
the top of the brine well. Feed the other end
of the brine tubing through the hole in the
side of the brine tank, and firmly insert it
all the way into the push-lock elbow fitting
inside the brine well. When this tubing is
fully inserted, the fitting will grab the tubing
and hold it in place.
Nut
Insert
Ferrule
INSTALLATION INSTRUCTIONS
