Ignis Operations Manual
Drone Amplified
LOW BATTERY:
Ignis battery voltage dropped below a safe level (11.4 V on Ignis 1, 6.8 V on
Ignis 2). Use the app to check that the battery voltage is above this safe level. If it is, and
you don’t need to drop many more ignition spheres, attempt to restart dropping.
Otherwise, land and replace the battery. If Ignis is idle and the battery is close to or
lower than the safe level, then dropping is not recommended, as the battery voltage will
likely dip below the safe level while Ignis is puncturing an ignition sphere, which will
trigger this error again.
NO CONNECTION TO IGNIS:
The app is not receiving messages from Ignis, and has
disabled dropping. Reconnect the app to the controller. You will also see this message if
you have not activated the Onboard SDK on an M600 (See section 9).
LOST CONNECTION TO APP:
Ignis stopped receiving messages from the app, and
disabled dropping. Reconnect the app to the controller.
WRONG DRONE MODE:
Remote controller was switched to mode A. Or, the drone lost
connection to the remote controller. Switch the remote controller into mode P or F.
Regain radio connection between the controller and the drone. This error may also occur
if the drone’s configuration in DJI Assistant 2 is incorrect. Verify the configuration in DJI
Assistant 2 matches the configuration in 9.
LOST CONNECTION TO DRONE:
Ignis is not receiving any signals or messages from the
drone. Check that the USB cable from Ignis is connected to the drone.
LOST DRONE PWM:
Ignis is no longer receiving PWM signals from the drone. Ensure the
usb cable that connects Ignis to the drone is fully inserted. For M600 users, check that
the green-wrapped cable is plugged into the flight controller.
LOST DRONE PWM 0:
Ignis is no longer receiving one of the PWM signals from the drone.
For M600 users, check that the green-wrapped cable is plugged into the flight
controller, and none of the wires are broken.
LOST DRONE PWM 1:
Ignis is no longer receiving one of the PWM signals from the drone.
For M600 users, check that the green-wrapped cable is plugged into the flight
controller, and none of the wires are broken.
LOST DRONE PWM 2:
Ignis is no longer receiving one of the PWM signals from the drone.
For M600 users, check that the green-wrapped cable is plugged into the flight
controller, and none of the wires are broken.
LOST DRONE DATA:
Ignis is no longer receiving messages from the drone’s API port. For
M600 users, check that the blue-wrapped cable is plugged into the flight controller.
Last Updated
Page 120
Apr 13, 2022
