Drolet HEATMAX II DF01001, Инструкция по установке и эксплуатации

Страница: 55 / 79

HeatMax II Furnace Installation and Operation Manual
55
10. Install the new door gasket (A). To do this, use about 1/4" (6 mm) of adhesive to the
bottom of the groove that holds the gasket in the door. Then lay the new gasket starting
from the center of the hinge side and taking care not to stretch the gasket during
installation. Leave about 1/2" (13 mm) of gasket exceed the frame of the door. Once
jointed, push the fibers protruding towards the inside of the groove in the adhesive.
Install the door and let dry for 24 hours before using the furnace
.
Do not abuse the glass door by striking or slamming shut. Do not use the furnace if the
glass is broken. To change the glass, perform the same operation described above.
9.1.5 Cleaning and painting the furnace
Do not attempt to clean or paint the furnace when the unit is hot. Painted surfaces
can be wiped down with a damp cloth. Plated or enameled surfaces may be scratched by
abrasive cleaners. To maintain the finish at its original brilliance, use only a damp soft cloth
to clean plated or enameled surfaces.
If the paint becomes scratched or damaged, you can give your wood furnace a brand new
look by repainting it with heat-resistant or enamel finish paint. Before painting, roughen the
surface with fine sand paper, wipe it down to remove dust, and apply two thin coats of
paint. For best results, use the same paint that was originally used on the furnace, which is
available in spray cans. See your dealer for details.