DriveTest FM100BT, Руководство пользователя

Страница: 41 / 47

Schließkraftmessgerät FM100BT
Version 1.7 Seite 41/47
4.4.2 Start measuring
The measurement is started by a short button press. Alternatively, it can be
started through the software (either PC or Android device). During the
measurement the LED shows a yellow light and the measured values are
displayed in the software.
Figure 14: Device during measurement
Permanently yellow

Device is measuring
The device will perform a taring action after initiating the measurement. This
will take about 0.5 seconds. If there is a force applied to the measuring device
during this period, then the following values will be decreased by this value.
The measurement will be stopped automatically if the measuring values will
be below the defined force value for a certain time period. If the measurement
should be stopped earlier then it can be done manually by pushing the stop
button either on the measuring device or in the software.
The LED will show a permanently blue light after stopping the measurement.
4.5 Turning Off
Pushing the button on the measuring device for a time period longer than 3
seconds will turn the device off. Alternatively, the device can be turned off by
the Android App (see chapter 4.1 “Funktionsübersicht Android App”).
4.6 Charging
The LED on the measuring device will give feedback about the remaining
battery in certain cases. If the LED is showing a permanently red LED after
turning it on then the device has to be charged.