Drive U-drive IFU, Руководство пользователя

Страница: 10 / 16

U-Drive IFU Page 9 Issued 10/11
If the LEDs on the battery gauge are
stepping up (i.e. the number of LEDs lit
quickly increases then resets to 1), the
battery charger is connected and the
wheelchair drive inhibited.
If the battery gauge is flashing slowly then
the wheelchair is operating normally, but the
batteries need recharging as soon as
possible.
If the battery gauge LEDs are flashing
rapidly this indicates a fault with the
wheelchair. If you have a problem with your
wheelchair consult the table below. If the
problem persists after you have followed the
advice herein then restarted the wheelchair,
contact your dealer.
1 Bar
The battery needs
charging or there is a
bad connection to the
battery. Check the
connections to the
battery. If the
connections are good, try
charging the battery.
2 Bar
The left hand motor has
a bad connection. Check
the connections to the
left hand motor.
3 Bar
The left hand motor has
a short circuit to a
battery connection.
Contact your service
agent.
4 Bar
The right hand motor has
a bad connection. Check
the connections to the
right hand motor.
5 Bar
The right hand motor has
a short circuit to a
battery connection.
Contact your service
agent.
6 Bar
The wheelchair is being
prevented from driving
by an external signal. The
exact cause will depend
on the type of wheelchair
you have, one possibility
is the battery charger is
connected.
7 Bar
A joystick fault is
indicated. Make sure that
the joystick is in the
centre position before
switching on the control
system.
8 Bar
A control system fault is
indicated. Make sure that
all connections are
secure.
9 Bar
The parking brakes have
a bad connection. Check
the parking brake and
motor connections. Make
sure the control system
connections are secure.
10 Bar
An excessive voltage has
been applied to the
control system.
This is usually caused by
a poor battery
connection. Check the
battery connections.
10 Bar +
Speed
This is where the Speed
Indicator and 10 bars are
lit.
A communication fault is
indicated. Make sure that
joystick cable is securely
connected and not
damaged.