17
RTS HUMIDIFIER RX SERIES INSTALLATION, OPERATION, AND MAINTENANCE MANUAL
Mounting
WARNING
Mounting hazard
Mount humidifier per the instructions
in this manual and to a structurally
stable surface. Improper mounting of
the humidifier can cause it to fall or tip,
resulting in severe personal injury or
death.
WALL MOUNTING THE HUMIDIFIER (MODELS -1 OR -2 STAGE UNITS)
Mount the humidifier level and plumb, using the lag bolts
provided. Follow the
instructions below for mounting on a stud wall with wood studs 16" (406 mm)
on center.
1. Mark hole locations at centers of studs, and predrill 1/4" (6 mm) diameter
pilot holes.
2. Secure cabinet to wall with lag bolts provided. See mounting keyholes in
Notes:
• Use the appropriate mounting methods and mounting hardware for other
wall types.
• Ensure the selected mounting location and humidifier orientation provides
adequate maintenance clearances and is at an easily serviceable height.
• Install a drain pan where appropriate to prevent equipment or building
water damage.
• A structural engineer must ensure the wall mounting surface and fasteners
are suitable and properly installed for the weight of the RX (see weights on
• Arrange appropriate lifting mechanism and personnel to mount the RTS RX
humidifier on the wall. See Warning.
• Single stage units are not designed to be base mounted.
OM-8043
-1 models: 21.32" (542 mm)
-2 models: 28.00" (711 mm)
16" (406 mm)
1.10" (28 mm)
Keyhole for
3/8" dia. (M10)
fasteners (4)
FIGURE 17-1: RTS HUMIDIFIER MOUNTING KEYHOLE LOCATIONS AND
DIMENSIONS
INSTALLATION
-1 models: 1.35" (34 mm)
-2 models: 1.80" (46 mm)
WARNING
HEAVY OBJECT
To avoid muscle strain or back
injury, use lifting aids and proper
lifting techniques when removing or
replacing.