Drinkpod DPWPA600FS B, Инструкция по использованию и уходу

Страница: 13 / 22

Maintaining Your DRINKPOD
Maintaining Your DRINKPOD 4-2
Mode/Tank Capacity To Flush
Cold (+
Reserve) 0.79 GAL (3 L) + 1.06 GAL (4 L) +1 GAL (3.79 L) ≈ 3 GAL (11 L)
Hot 1.32 GAL (5 L) +1 GAL (3.79 L) ≈ 3.5 GAL (9 L)
9. Your finished!
Storing & Relocating Your DRINKPOD 6
At some point, you may need to store or relocate your DRINKPOD 6. Should one of these
situations be the case for you, below are a few simple steps to prevent any damage from
occurring.
1. First, if the cooling and/or heating systems are powered on, flip
U
Cooling System Power Switch and
T
Heating System Power Switch into the
down position to power off. This should always be done prior to shutting off water
supply.
2. Shutoff the waterflow to your DRINKPOD at the water source (i.e. your icemaker
hookup or under your sink
3. Shutoff water flow to your appliance by turning the blue handle on the
C
1/4 in. Quick Connect Shutoff Valve (see Installation Guide) connected to your
DRINKPOD’s
M
Water Input Port
located at the back of the appliance.
4. Place a cup below dispensers and dispense water from both hot and cold modes until
water stops coming out.
5. Grab a container with high sides, like a bucket or pitcher, and place it on the floor in
front of your DRINKPOD 6.
6. Pull your DRINKPOD counter-clockwise away from the wall, and rotate it as necessary
to allow for room for your container beneath the
V
Appliance Drain Port is
extended over the edge.