Page 10
For technical questions, please call 1-800-444-3353.
Item 61626
SAFET
y
Op
ERA
TION
M
AINTENAN
c
E
SETU
p
Installing the Fence
Use the Fence to make cuts parallel to
the edge of a workpiece, or following a
guide clamped onto the workpiece.
1. Install the Fence Bracket with the Fence
facing inward, and the flanges down.
2. Using the Attachment Knob, attach the Fence Asm.
to the Router, as shown in
Figure A
.
3. After measuring the proper distance
from the router bit to the Fence, tighten
the Fence using the Wing Nut.
4. Adjust the cutting depth as described in
Adjusting Cutting Depth
on page 9.
5. Make a test cut on a piece of scrap material
to ensure that the adjustment is correct.
Fence
Attachment
Knob
Wing
Nut
Figure A: Installing the Fence
Setting up a Temporary Guide
Clamp a temporary guide to the workpiece
to make a straight cut which does not
parallel the edge of the workpiece.
1. Clamp a suitable straight board across the
workpiece parallel to the desired location of the cut.
2. Install the Fence Asm. with the Fence facing
outward and up, as shown in
Figure B
.
3. After measuring the proper distance from the
router bit to the temporary guide, tighten the Fence
using the Attachment Knob and Wing Nut.
4. Make a test cut on a piece of scrap material
to ensure that the adjustment is correct.
Fence
hole
(for circle
cuts)
Attachment
Knob
Wing
Nut
Fence
Bracket
Figure B: Fence Installation for Use with a
Temporary Guide and for circle cutting
circle cutting
Use the center hole in the Fence as a
pivot point when cutting circles.
1. Install the Fence as shown in
Figure B
.
2. Drill a small pilot hole at the center point of the circle.
3. Set the distance from the center hole in the
Fence to the far edge of the router bit equal to
the radius of the circle. Lock the Fence in place
with the Attachment Knob and Wing Nut.
4. Insert a pin (not included) through the center
hole in the Fence and into the pilot hole.
Содержание 61626
Страница 1: ......
