Page 11
For technical questions, please call 1-800-444-3353.
Item 61626
SAFET
y
Op
ERA
TION
M
AINTENAN
c
E
SETU
p
Installing the Trim Guide Asm.
Use the Trim Guide to trim in relation to both the
workpiece’s top surface and its edge surface,
so the Router must be adjusted to
cut accurately in two dimensions.
1. Assemble the Trim Guide as shown in
Figure c
, and attach to the Router Base.
2. Adjust the Router Base so the cutting
depth will be flush with the surface that
you will be trimming to match.
3. Loosen the Attachment Knob and adjust
the Trim Guide so that its Guide Wheel is
below the bit by approximately 3/4″ to 1″.
Tighten it in position using Attachment Knob.
4. Center the cutting bit over the edge to be
trimmed by loosening Lock Knob and sliding the
Guide Block into position. Tighten Lock Knob.
Note:
To make fine adjustments, partially loosen
Lock Knob and use Edge Knob.
When the adjustments are finalized,
tighten Lock Knob.
5. Make a test cut on a piece of scrap material
to ensure that the adjustment is correct.
Attachment
Knob
Edge
Knob
Lock Knob
Guide
Block
Guide
Wheel
Figure c: Trim Guide Asm.
Workpiece and Work Area Set Up
1. Designate a work area that is clean and well lit.
The work area must not allow access by children
or pets to prevent distraction and injury.
2. Route the power cord along a safe route to reach
the work area without creating a tripping hazard or
exposing the power cord to possible damage. The
power cord must reach the work area with enough
extra length to allow free movement while working.
3. Secure loose workpieces using a vise or clamps
(not included) to prevent movement while working.
4. There must not be objects, such as utility lines,
nearby that will present a hazard while working.
General Operating Instructions
1. Make sure that the Power Switch is in
the off-position, then plug in the tool.
2. Turn the Power Switch on and run the tool or
about 10 seconds before routing to ensure
that all moving parts are running smoothly,
and there are no loose parts, rattles, or
sparking that would indicate damage.
3. When using the Fence: Cut parallel to the edge of
the workpiece with the Fence following the edge.
4. When using a Temporary Guide: Cut with the
Fence following the edge of the temporary guide.
5. When making a circle cut: With the pin located in the
pilot hole, plunge the router bit into the workpiece,
and rotate the router in a circle around the pilot hole.
Note:
The router bit rotates clockwise.
Adjust for this while cutting:
a. For most materials it is best to move the Router
from left to right as facing the workpiece.
b. When cutting outside edges, move the
Router counterclockwise. When cutting
inside edges, move the Router clockwise.
6. To prevent accidents, turn off the tool and
disconnect its power supply after use. Clean, then
store the tool indoors out of children’s reach.
Содержание 61626
Страница 1: ......
