07-01742C F435-DV (110–230V UK)
6
Legend Brands Holdings, Ltd.
CLEANING
Safety Precautions
IMPORTANT. Unplug unit from electrical supply
before starting to clean.
Filter
1. Optional 4-PRO filters should be replaced
whenever the accumulation of dust or debris is
visible.
2. Standard fibreglass and paper filters cannot be
cleaned and should be replaced when full.
External Cleaning
1. Wipe surfaces with damp cloth.
Internal Cleaning
1. Remove 2 screws on top of moulded cover.
2. Hinge open moulded cover
3. Slide up and remove Fan Shroud (A) for cleaning.
4. Remove four plastic snap rivets from Coil Shroud
(B) and lift off shroud. To remove rivets, press up on
the center rivet pin underneath the shroud until
flanges are released. The rivets may then be lifted
out of the shroud and the shroud can be removed.
5. Vacuum coils (C).
6. Clean pumpout. See “Pumpout Cleaning” below.
7. When finished, replace Fan Shroud and Coil
Shroud and secure with fasteners. Ensure that the
power cable and strain relief is correctly positioned
into cable outlet slot on chassis. Hinge the cover
closed. Secure cover with 2 screws.
Pumpout cleaning
1. After opening the housing, remove screws (A) and
(B). Remove drain hose from basin cover. 2. Slide
pump assembly out and place on firm surface
(electrical cable will remain attached). 3. Lift pump
off catch tray. Wipe out tray with a clean cloth. 4.
Reassemble, slide tray in and reattach with screws.
Make sure electrical cable is tucked in neatly above
the pump before closing lid.
NOTICE: Pump and check valve should be
inspected and cleaned after each job or at least
once per month.
