© DreamLine
All Rights Reserved
© DreamLine
All Rights Reserved
© DreamLine
All Rights Reserved
© DreamLine
All Rights Reserved
18
FLEX 42x72 48x72 54x72 60x72 60x58 Shower and Tub Door manual Ver 1 Rev 4 072019
©2019 DreamLine. All Rights Reserved
Fig 19
Fig 20
inside
Ø1/8”
(3mm)
Ø1/8”
(3mm)
ST4.2x10 &
washer
Decorative cap
1
2
3
4
5
6
Ø1/8”
(3mm)
Ø1/8”
(3mm)
1
2
3
4
5
6
ST4.2x10 &
washer
Decorative cap
inside
inside
Right hand door installation shown
overhead view
door
panel
!
!
inside
inside
inside
inside
inside
washer
screw
decorative cap
19a.
Once all adjustments have been made,
drill pilot
holes from inside of the shower into the
Top & Bottom
Pivot Rails (#15)
through the predrilled holes using an
Ø1/8” drill bit
.
19b.
Secure the Expanding rails using the
Round Head
Screws ST4.2×10 (#04)
and the raised white
washers
.
Cover the exposed screw heads and washers with the
Decorative Caps (#06)
.
(Fig 19)
NOTE: Do Not
drill the rails throughout,
only through the first layer.
20.
Make any final adjustments to the Door assembly within
the
Wall Profiles (#01)
. Make sure that the entire assembly
sits tight down onto the threshold.
From inside the shower, drill holes near the center of the
Wall
Profiles (#01)
at the top and bottom of the profile using an
Ø1/8” drill bit
. (Fig 20.1 and 20.2)
NOTE: Do Not
drill the profiles throughout, only
through the first layer.
Secure the Door assembly to the
Wall profiles (#01)
using the
Round head screws ST4.2×10 (#04)
and the raised white
washers
.
Cover the exposed screw heads and washers with the
Decorative Caps (#06)
. Repeat this step on the strike side wall
profile as well.
(Fig 22)