©2017 DreamLine. All Rights Reserved
19
ENIGMA Z Enclosure Manual Ver 1 Rev 4 04/2017
3
2
1
The Guide Block (#12) must be
installed squarely onto the threshold
and stationary panel glass
Fig. 20
Fig. 19
2
1
Painter’s Tape
Use Caution
outside
panel glass
90°
anti-splash guard
overhead view of
guide block and
stationary panel glass
on threshold
!
protective
padding
right-hand installation shown as an example
19.
Re-position the Stationary Glass (#02) and Upper Guide Rail (#03) onto the threshold and fasten
the sleeves of the Guide Rail Brackets (#08) to the bracket on the wall and to the Glass Connector (#21)
on the Return Panel Glass (#22).
Tighten the set screws on the Guide Rail Brackets (#08) to secure the Upper Guide Rail (#03).
Make sure to position the bracket set screws so that they are accessible from the top and bottom.
(As shown in Step 16, Fig. 17).
18
.
Carefully p
lace the Stationary Glass (#02) with the Upper Guide Rail (#03) onto the threshold
with the notch fitting into the
Guide Block (#12).
Position the Stationary Glass (#02) against the wall.
(Please note that the Stationary Glass (#02) installs on the outside and the Upper Guide Rail (#03)
goes on the inside of the shower). (Fig. 19)
Assemble the Wall Bracket (#19) at the bottom corner of the Stationary Glass (#02). Use the clear vinyl
gasket between the glass and the metal parts to avoid contact with the glass, then tighten the bolt with
the supplied allen wrench. (Fig. 20)
