©2017 DreamLine. All Rights Reserved
17
ENIGMA Z Enclosure Manual Ver 1 Rev 4 04/2017
2
1
4**
3**
1
2
Fig. 15
Separate the
Guide Rail Bracket (#08)
sleeve from the base by
loosening the set screws (leave the sleeve on the upper guide rail
and tigthen the set screws)
Ø5/16”
(8mm)
Ø3/8”
(10mm)
or Ø1/4”
(6mm)
**
Ø1/4”
(6mm)
Fig. 16
!
base
sleeve
Wall bracket (#19)
Guide Rail bracket (#08)
**NOTE: The manufacturer strongly recommends
installing the guide rail brackets into studs or
pre-installed 2”x 6“ wood reinforcements behind
the wall.
For installation into a stud,
drill a Ø1/4” hole up to
the stud and let the screw
bore into the wood.
Do not use the wall
anchors.
15.
Drill the hole for the Wall Bracket (#19) using a
Ø5/16” drill bit and insert the Wall Anchors (#9b)
(Fig. 16.1)
**Drill the holes for the Guide Rail Brackets (#08) using
a Ø3/8” drill bit and insert the Wall Anchors (9a).
(Fig. 16)
14.
Carefully s
et the Stationary Glass (#02) and
Upper Guide Rail (#03) aside, along with the Guide
Block (#12) and Anti-Splash Guard (#15).
Remove the Guide Rail Brackets (#08) from the
Upper Guide Rail (#03) (as shown below) and the
Wall Bracket (#19) from the Stationary Glass (#02).
Place the Wall Bracket (#19) and Guide Rail
Bracket (#08) back to the outlined positions and
mark the holes for drilling. (Fig. 15)
