5
6
1. When the cycle is complete, the display will flash 00:00 for 60 seconds and then shut off,
allowing contents to cool slightly before removal.
Promptly
remove vessel to avoid
overheating. Gently stir or swirl content to ensure it warms evenly. DO NOT shake.
CAUTION: Open lid by front tab and carefully remove contents
by hand or with lift-out basket. Beware of steam and avoid
spilling or splashing water on yourself when removing contents.
Note: If removing lift-out basket, carefully empty liquid that collected from steam.
STERILIZING
This appliance can sterilize any item that can withstand boiling water, such as
pacifiers/soothers, teethers, toys and utensils.
1. Wash items to be sterilized in hot, soapy water and rinse well.
2. Follow steps 1-3 in Preparing for Use section.
3. Ensure warming basket and lift-out basket are in warming chamber. Never use without baskets
in place.
4. Place item into sterilizer as outlined below.
BOTTLE: Place reservoir tube and bottle upside down in
in lift-out basket. Lower into warming basket. Put remaining
items inside lid.
SMALL ITEMS: Place items into lift-out basket, then lower into warming basket.
Put remaining items inside lid.
5. Close the lid.
6.
Press the Power Button.
Press the Starting Temperature Condition Button until the Sterilize icon appears.
The appliance will default to 6:00.
Press the Cycle Start Button.
WARNING: DO NOT open lid or reach over the appliance while in
use, as steam will cause burns and serious injuries. DO NOT touch hot
surfaces, including lid and interior parts, during use.
7. When the cycle is complete, the display will flash 00:00 for 60 seconds and then shut off,
allowing contents to cool slightly before removal.
CAUTION:
Open lid by front tab and carefully remove contents by hand or with
lift-out basket. Beware of steam and avoid spilling or splashing water on
yourself when removing contents.
Sterilize
1
2
3
4
5
6
7
8
9
8
TROUBLESHOOTING
If the warmer is not operating, check that:
1. The power cable is connected to the power outlet.
2. Water has been added to the reservoir.
3. The appliance is correctly assembled.
4. If display shows the error “ERR-H2O,” the warmer has low water condition. Unplug from
power. Fill water to the correct level. Reconnect to Power.
CLEANING
CAUTION: Unplug from outlet and allow to cool before cleaning
and descaling.
DO NOT IMMERSE IN WATER.
Note: Regularly check the heating plate for milk residue or mineral deposits. As
mineral deposits build, it can slow or disrupt the warming process/sterilizing cycle.
Using non-mineral bottled water can help prevent buildup, but regular descaling is
needed for best performance. See cleaning instructions below to remove milk and
descaling instructions to remove mineral deposits. DO NOT use bleach, scouring
pads, abrasive cleaners or solvents for cleaning or descaling.
WARMING CHAMBER: Wipe all surfaces with a damp cloth or sponge.
WARMING BASKET,
LIFT-OUT BASKET, LID AND RESERVOIR: Clean in hot, soapy water
and rinse well, or in a dishwasher (top rack only). Allow to air dry.
WARRANTY
This warming appliance is warranted against defective material or workmanship for
a period of one year from the date of purchase.
Any defective part will be repaired or
replaced at no charge if it has not been tampered with and appliance has been used
according to these printed instructions.
This warranty does not cover a defect that has been caused by negligence, accidents or
improper use of the appliance. To keep this appliance in good condition and retain your
warranty, USE ONLY AS DIRECTED.
CUSTOMER SERVICE
If you experience unsatisfactory operation or have questions/comments,
please contact your
local Dr. Brown’s distributor. See drbrownsbaby.com/distributors to find your local contact.
1
2
3
4
Descaling
If buildup forms on the heating plate, follow the steps below.
• Empty reservoir and baskets.
• Descale utilizing a mixture of vinegar/water:
• Mix 50 mL (2 oz) of white vinegar with 100 mL (4 oz) of non-mineral bottled water
in reservoir.
Note: Ensure proper ventilation when cleaning with vinegar.
• Plug into wall outlet, press the Power Button and run a Sterilize cycle.
• When the cycle is complete, ensure the unit is off and remove plug from wall outlet.
Remove vinegar and water solution from warming chamber and reservoir.
Thoroughly rinse with clean water.
1
2
A
B
C
D
