Vigor2130 Series User’s Guide
200
4
4
.
.
6
6
.
.
3
3
P
P
o
o
r
r
t
t
R
R
a
a
t
t
e
e
C
C
o
o
n
n
t
t
r
r
o
o
l
l
A policer can limit the bandwidth of received frames. It is located in front of the ingress queue.
And a shaper can limit the bandwidth of transmitted frames. It is located after the ingress
queues. This page allows you to configure the switch port rate limit for Policers and Shapers.
Port
Represent LAN or WAN interface.
Policer Enabled
Check this box to enable policer function to limit the
bandwidth of received frames.
Policer Rate(Rx)
Type the number for policer function. The default value is
500. It is restricted to 500-1000000 when the Policer Unit is
set in kbps, and it is restricted to 1-1000 when the Policer
Unit is set in Mbps.
Policer Unit
Determine the unit (kbps/Mbps) for policer.
Shaper Enabled
Check this box to enable shaper function.
Shaper Rate (Tx)
Type the number for shaper function. The default value is
500. It is restricted to 500-1000000 when the Shaper Unit is
set in kbps, and it is restricted to 1-1000 when the Shaper
Unit is set in Mbps.
Shaper Unit
Determine the unit (kbps/Mbps) for shaper function.
Click
OK
to save the settings.
4
4
.
.
6
6
.
.
4
4
Q
Q
o
o
S
S
C
C
o
o
n
n
t
t
r
r
o
o
l
l
L
L
i
i
s
s
t
t
Deploying QoS (Quality of Service) management to guarantee that all applications receive the
service levels required and sufficient bandwidth to meet performance expectations is indeed
one important aspect of modern enterprise network.
One reason for QoS is that numerous TCP-based applications tend to continually increase their
transmission rate and consume all available bandwidth, which is called TCP slow start. If
other applications are not protected by QoS, it will detract much from their performance in the
overcrowded network. This is especially essential to those are low tolerant of loss, delay or
jitter (delay variation).
Another reason is due to congestions at network intersections where speeds of interconnected
circuits mismatch or traffic aggregates, packets will queue up and traffic can be throttled back
to a lower speed. If there’s no defined priority to specify which packets should be discarded
(or in another term “dropped”) from an overflowing queue, packets of sensitive applications
mentioned above might be the ones to drop off. How this will affect application performance?
There are two components within Primary configuration of QoS deployment:
Содержание Vigor 2130 Series
Страница 1: ......
Страница 10: ......
Страница 190: ...Vigor2130 Series User s Guide 180 Click OK to save the settings...
Страница 342: ...Vigor2130 Series User s Guide 332 This page is left blank...
