DRAWMER
10
SURROUND INPUTS
The eight balanced inputs to the CMC7 are via a 25 pin D-Sub connector wired to
the Tascam standard (Refer to ‘Audio Connections’ for wiring information). The
CMC7 does not have input level trims, and their is only one volume control that
effects all eight channels in exactly the same way regardless of the source origin,
be it surround 7.1, 5.1 or 8 independent sources, meaning any individual channel
volume level to balance the mix should be performed prior to reaching the CMC7.
7.1 SPEAKER OUTPUTS
The CMC7 has eight balanced outputs. Connection is via a 25 pin D-Sub connector
wired to the Tascam standard (Refer to ‘Audio Connections’ for wiring information)
and a 25 pin d-sub to 8x XLR snake should be used to connect each individual
speaker. It has no speaker output trims so monitor calibration should take place
after the CMC7 via active speaker adjustments.
PHONES
The headphone output is a 1/4” TRS jack that is capable of driving a wide number
of headphones from budget to professional - The
Headphone Volume
Level
knob
for the headphone amplifier is found on the top panel above the main volume
control
(4)
, and is used to trim the volume of the headphones.
Because the headphone amplifier is of such a high quality the headphone output
could also be used as a source for a second set of stereo monitors, should they be
required, the trim control being used for speaker level matching.
POWER
The CMC7 will be supplied with an external switching mode power supply that is
capable of 100-240Vac continuous (90-264Vac max) and should work globally, but
is supplied with a cable suitable for domestic power outlets in your country. We
strongly advise that the power supply that has been supplied with the CMC7 is
used, rather than one with the equivalent ratings. The push button switch activates
the CMC7. Note that a timed relay protection circuit has been incorporated into
circuit to prevent bangs and other potentially harmful artifacts from occurring during
power up and power down.
5
6
7
8
