Drawmer CMC3, Руководство пользователя

Страница: 15 / 20

CMC3
- Monitor Controller
Talkback Output: A dedicated ¼" mono talkback output jack can be found on the
rear panel, so that, as well as being routed through the headphones, a talkback
signal can be routed to other devices at the engineers discretion. This could usually
be patched into the live-room active monitor speakers for convenience when
recording acoustic ensembles where the performers may not wish or need to wear
headphones. It could also be used as an added channel on a mixing desk to be
patched into a multiple headphone amplifier along with the stereo mix, for example.
The jack also allows for routing into a separate channel of a DAW, or other recording
facility, to allow for information overdubs to be added to a recording.
To connect the mono talkback to a Dual Mono jack use the following cable wiring:
POWER
The CMC3 will be supplied with an external switching mode power supply that is
capable of 100-240Vac continuous (90-264Vac max) and should work globally, but
is supplied with a cable suitable for domestic power outlets in your country. We
strongly advise that the power supply that has been supplied with the CMC3 is
used, rather than one with the equivalent ratings. The push button switch activates
the CMC3. Note that a timed relay protection circuit has been incorporated into
circuit to prevent bangs and other potentially harmful artifacts from occurring during
power up and power down.
12
15