Section 6 -
Electrical Connections
(for Motorized Units)
Caution:
For motorized units, make sure POWER IS OFF before making any electrical connections. Use extreme caution when working with electric motors.
Shade operates on 110-120v, 60 Hz. current. Shade ships with internal wiring complete and control switch
(es)
fully boxed, and standardly supplied with a 6’ cable
lead. Longer lead can be substituted by removing two screws in motor end of roller, removing lead, plugging new lead in, and replacing screws. Wire to connect
shade to switch
(es)
and switch
(es)
to power supply should be furnished by installer. Connections should be made in accordance with attached wiring diagram,
and wiring should comply with national and local electrical codes. Only RTS and 485 motors can be wired in parallel.
Please Note:
All operating switches should be “off” before power is connected.
Please Note:
For low voltage wiring requirements, Draper recommends consulting with a professional low voltage electrical contractor. It is very important that
shielded and stranded CAT 5 cable be used to prevent any electrical interference.
Please Note:
Wiring diagram for standard right-hand motor placement with fabric from rear of roller, or left-hand motor placement with fabric from front of roller.
For left hand motor placement with fabric from rear of roller or right hand motor placement with fabric from front of roller, Red is “Up” and Black is
“Down.”
Please Note:
All Motorized LightBloc FlexShade motors are equipped with M12 Connectors.
Section 7 -
Wiring Diagrams
(for Motorized Units)
Data Cable
with RJ45
Connector
Data Hub
Bus Power
Supply
Controls & System Overview
Sonesse RS485 120VAC Motors
BUS OUT
to next
DATA HUB
BUS IN
STOP
Wall Switch
110V
Outlet
LAN
Dashed Wiring
by Electrician
M12
Connectors
RS485
120VAC
Motor
RS485
120VAC
Motor
B W G
110-120V Line
B W G
110-120V Line
DATA
CABLES
Dashed Wiring
by Electrician
NOTE: Test shade operation
If shade direction does not
correspond with the switch
orientation, turn power back
off and switch the red and black
wires from the motor to the switch.
Do not wire motors in parallel without
written permission from Draper.
Controls & System Overview
Sonesse 120VAC Motors
W B R G
B
Control
Switch
Single Gang
Box (by others)
120V
MOTOR
110-120V Line
M12
Connector
Dashed Wiring
by Electrician
Controls & System Overview
Sonesse RTS 120VAC Motors
M12 Connector
B W G
RTS
MOTOR
120V
110-120V Line
Decora RTS
Wireless Keypad
Telis 1
RF Remote
STOP
Data Cable Pin-Out - RJ45 Connector
MOTOR Pin-Out - RJ9 Connector
4 - GROUND - (BROWN)
3 - POWER + (BLUE)
2 - DATA - (ORANGE)
1 - DATA + (ORANGE/WHITE)
1 - DATA + (ORANGE/WHITE)
2 - DATA - (ORANGE)
3 - N/A (GREEN/WHITE)
4 - POWER + (BLUE)
5 - POWER - (BLUE/WHITE)
6 - N/A (GREEN)
7 - GROUND - (BROWN/WHITE)
8 - GROUND - (BROWN)
page 6 of 8
LightBloc FlexShade
®
