Section 1 -
Preparation for Installation
Please Note:
If unit is motorized with a crank override, skip this step. Roller
assembly and headbox assembly must be installed as a unit — the roller
assembly cannot be removed without completely disassembling headbox.)
FOR CRANK OR MOTORIZED UNITS:
Remove black plastic retainer clip from
idler end of roller and retainer clips from motor studs. Save these clips to replace
when re-assembling. Lift idler out of bracket Depress spring-loaded pin by pressing
roller toward pin end endcap until clutch hooks are free from operator endcap.
Remove roller assembly from headbox.
FOR BEAD CHAIN CLUTCH UNITS:
Lift up on clutch end so that clutch hooks
can disengage from operator endcap. Depress spring-loaded pin by pressing roller
toward pin end endcap until clutch hooks are free from operator endcap. Remove
roller assembly from headbox.
Please Note:
It may be necessary to locate and drill a hole for conduit connector
(Conduit connector is not supplied)
(Fig. 4)
.
FOR ALL:
Verify dimensions of opening and refer to order for overall dimensions
of unit. Determine location of headbox directly above and centered on opening.
It is critical that headbox is installed absolutely level
(use shims and caulking if
needed)
. Install headbox assembly using appropriate fasteners through pre-drilled
holes in endcaps, then drill through cover for wall/ceiling mounting
(Fig. 5)
.
2.
FOR ALL:
Remove face cover from
headbox by pulling down and out on
bottom edge of cover near endcaps. It
will snap off
(Fig. 2)
. If this is a pocket
installation, remove screws at endcaps.
Bottom of cover box snaps down and
off at endcaps then slides out of slot in
cover box
(Fig. 2)
.
3.
FOR ALL:
Remove roller assembly
from headbox.
Caution:
Before mounting shades, verify measurements on package label with shade.
Please Note:
Installer is responsible for selecting mounting hardware appropriate for site conditions.
1.
FOR ALL:
Open cartons lengthwise. Remove all pieces from carton. If shade has a detachable crank handle, remove universal
joint and shaft/bracket assembly by removing 2 screws from bottom of endcap
(Fig. 1)
. Save universal joint & screws.
Figure 1
Crank Endcap
& Assembly
Crank
Handle
CRANK ASSEMBLY
Figure 2
Wall/Ceiling
Be sure retainer clip is installed.
Idler
Endcap
Idler End
of Roller
Retainer Clip
Idler
Endcap
Idler End
of Roller
Retainer Clip
Idler
Endcap
Idler End
of Roller
Retainer Clip
Idler End
Operator End
Motorized
Crank
Bead Chain Clutch
4
Replace
Slide & Screw
20lb Clutch
Clutch
Endcap
2
Then
Remove
Slide
1
First
Remove
Screw
Idler
Endcap
3
Retainer
Clip
Insert
Spear
Idler
Endcap
Snap On
Endcap Covers
6
5
Clutch
Endcap
Route Bead Chain
Through
Chain Guide and
Attach Cover
Idler
Endcap
Figure 3:
Be sure retainer clip is installed.
To
p
End
Bac
k
1
1
/
2
"
1
1
/
2
"
3
/
4"
3
/
4"
5
/
8
5
/
8
Figure 4
Figure 5
Wall/Ceiling
(face)
or Jamb Mount
Existing Pocket
page 3 of 8
LightBloc FlexShade
®
