Draper Expert 70052, Инструкция по эксплуатации

Страница: 9 / 18

– 9 –
Argon
Gas
5 FIG.
6 FIG.
7.3 TIG WELDING FOOT PEDAL
CURRENT CONTROL – FIG.7
The foot pedal
(10)
allows the welding current to be
adjusted remotely from the main welding unit.
To connect the foot pedal:
− Plug both the 6 pin
(3.1)
and 2 pin
(2.1)
connector
plugs of the foot pedal into the corresponding ports
(3)
/
(2)
located on the machine (the 2 pin plug
connector of the TIG torch
(7.1)
becomes redundant
and can be left hanging loose).
Operation:
− Set the dial
(10.1)
located on the side of the pedal to
the desired current output.
− Depress the foot pedal to activate. The resulting
pressure placed on the pedal controls the level of
current incrementally until the maximum level, set by
the dial is reached.
7 FIG.
7.4 MMA (MANUAL METAL ARC)
SETUP – FIG.8
− To attach the electrode holder
(9)
to the front panel,
insert the plug into the connection port marked ‘ ’
(1)
and twist to lock.
− Attach the earth clamp
(8)
into the connection port
marked ‘ ’
(5)
– plug in and twist to lock.
8 FIG.
7.5 MMA/ARC WELDING FILLER ROD
(ELECTRODE) SELECTION – FIG.9
The correct selection of electrode size and type will vary
for each application dependent upon material thickness,
material type, amperage and equipment, however as a
guide the figures below provide an indication.
MMA Electrode Material
Thickness
Amp Range
≤
1.6mm 1-1.5mm
≤
50A
2.0mm 1.2-3mm 45 - 75A
2.5mm 2-5mm 75 - 110A
3.25mm 4-8mm 100 - 150A
(1)
(2) (3) (4) (5)
(7.1)
(7)
(8)
(3.1)
(10.1)
(10)
(2.1)
(8) (9)