page 8 of 10
Dual Roller FlexShade
®
NEXD
Section 8 -
Bead Chain Limits and Safety Device Installation
Attaching Stop Balls
1.
Set upper and lower travel limits by installing stop balls to bead chain
(crimp closed using pliers)
(Fig. 9-A)
.
P-Clip Cord Tension Device
Please Note:
Draper
®
Bead Chain Clutch-Operated shades that do not comply with WMCA/ANSI Standard A100.1-2012
come with a P-Clip cord tension device pre-attached to bead chain
(Fig. 9-B)
. This device must be attached to wall,
jamb, or sill so that bead chain is held taut enough that children cannot pull it away from wall or fit their head into loop.
Spring-Loaded Cord Tension Device
If Draper Clutch FlexShade complies with WMCA/ANSI Standard A100.1-2018, a Spring-Loaded Cord Tension Device
comes installed on bead chain
(Fig. 9-C)
. An approved permanent warning label and approved mechanical fasteners
(wood
screws)
are included. Device is designed so that children cannot pull bead chain away from wall or fit their head into loop.
(See safety note on page 2)
. For more information, visit
www.draperinc.com/WindowShades/WCMAcompliance.asp
.
1.
Install cord tension device to wall, jamb, or sill.
2.
Pull tensioner down so that bead chain is held taut and use mounting hardware to keep it taut.
Please Note:
Bead chain should be taut enough to move smoothly through device. However, overtightening screws will
damage Spring-Loaded Tension Device.
Section 7 -
Attaching Fascia
A.
Position fascia flush to edge of bracket
and/or butted to endcap cover.
B.
Snap firmly into place.
Please Note:
Fascia should be
installed top to bottom, with the
bottom edge clicking/snapping
into position.
A
Fascia is not
fully seated until
it clicks into place
on both ends.
!
B
CLIC
K
!
A
B
CLICK
!
NEX
D Clu
tch
Endc
ap
N
EXD
Idl
er
En
dca
p
Ensure that fascia engages
with the metal portion
of the endcap.
!
Figure 8-A
Figure 8-B
Chain Limits
Chain Tension Device
Figure 9-A
1. Attach
stop balls.
2. Crimp
closed
with
pliers.
Sill
Mount
Jamb
Mount
Tensioner
P-Clip
Figure 9-B
P-Clip
Figure 9-C
STEP 1
STEP 2
Clicks into place.
Insert
fascia.
SIDE
VIEW
