page 6 of 10
Dual Roller FlexShade
®
NEXD
Section 4 -
Shade Fabric Roller Mounting
TOP ROLLER ASSEMBLY
BOTTOM ROLLER ASSEMBLY
1.
Carefully work
open
(clutch)
end
of TOP roller onto
bead chain clutch.
2.
Slide idler pin end
of the top roller up,
through one of the
slots on idler endcap,
and into seat for pin.
NOTE:
Illustration shows
different path options.
3.
Carefully work
open
(clutch)
end
of BOTTOM roller
onto bead chain
clutch.
5.
Test shade to ensure that
roller is level and operating
properly.
If not, adjust idler leveling
screw with 3mm Hex Wrench,
available upon request when
ordering shade.
4.
Slide idler pin end of the
bottom roller up, through one
of the slots on idler endcap,
and into seat for pin.
Caution:
Do not allow shade roller to become exposed by lowering shade fabric too far.
Be sure to use stop balls provided by Draper
®
to set up and down travel limits. Stop balls
by others may be too small, and become lodged in clutch.
Please Note:
If shade fabric is tracking to one side, see
"Field Adjustments," Page 2.
Tube indentation
must be aligned
with the FLAT side
of the clutch sprocket.
!
OPER
ATOR
(CLUTC
H)
END,
TOP RO
LLER
A
SSEM
BLY
OPERA
TOR
(CLUTCH
)
END,
BOTTOM R
OLLER
ASSEM
BLY
Tube indentation
must be aligned
with the FLAT
side of the
clutch sprocket.
!
IDLE
R
(PIN)
END
,
TO
P RO
LLER
A
SSEM
BLY
NOTE
:
Illustration shows
different path options.
◄◄
I
DL
ER
P
IN
P
AT
H
B
◄◄
IDL
ER P
IN P
ATH A
IDLE
R
(PIN)
END
,
BO
TTO
M RO
LLER
A
SSE
MBL
Y
◄◄
IDLER PIN PATH B
◄
◄
ID
LER P
IN PATH A
◄
◄
ID
LER P
IN PATH A
NOTE:
Illustration
shows different
path options.
IDLER
LEVELING
SCREW
3mm
HEX W
REN
CH
Figure 5-A
Figure 5-C
Figure 5-B
Figure 5-D
Figure 5-E
