page 3 of 10
Dual Roller FlexShade
®
NEXD
Section 1 -
Mounting Endcaps
1.
Mark surface for placement of endcaps.
2.
Drill small starter hole
(if necessary)
in mounting
surface.
3.
Snap endcap covers onto endcaps
(Fig. 1)
.
Please Note:
If endcap covers have been
provided with the shade order, they are included
in the width of the shade measurement and
must be used
.
CAUTION:
If installing without a headbox,
proceed to
Figure 2, below, NOW
.
If installing with a Dual Roller Ceiling/Wall
Headbox,
proceed to Section 2 NOW
.
If installing with a Dual Roller Pocket
Headbox,
proceed to Section 3 NOW.
4.
Mount endcaps using appropriate fasteners for
surface
(Fig. 2)
.
Please Note:
If installing Pocket Headbox or Surface Headbox,
please install headbox FIRST
(Section ????)
.
Caution:
Before mounting shades, verify measurements on label provided with shade, and ensure unit is installed at correct width.
Please Note:
Installer is responsible for selecting mounting hardware appropriate for site conditions.
please
note
Endcaps must be fastened securely
to mounting surface and cannot move
from side to side.
If changes, differences, or
measurement errors occur on-site,
adjust product by utilizing
slotted
holes in the endcap [
A
] to adjust for
zero gap between the fascia and
endcap covers.
Once these adjustments are made,
utilize
round
holes [
B
] to drive
additional screws for securing
position.
Please Note:
If installing shade or shades in an area
where misuse is likely, this fastening method should
be used.
SNA
P-O
N
SNA
P-O
N
SNA
P-O
N
SNAP
-ON
SNAP
-ON
SNAP
-ON
END
CAP CO
VER
END
CAP
COV
ER
Snap endcap
covers
into place.
Figure 1
Figure 2-A
Mount endcaps
to ceiling.
Mount endcaps
to ceiling.
Mount endcaps
to wall.
Mount
endcaps
to jamb.
PLEASE NOTE:
If endcap covers are included in order,
drill through endcap cover and secure with endcap.
Endcap requires a minimum of
two
fasteners.
It is
not necessary
to utilize all four corners.
CEILING MOUNTING
WALL MOUNTING
JAMB MOUNTING
Figure 2-B
Figure 2-C
A
B
