Draper CSP2625, Инструкция по эксплуатации, Страница: 17 / 36

17
– Slot all the drive links in to the guide bar groove.
Fit the drive links at the tip of the bar correctly
around in to the nose sprocket teeth.
– Slide the guide bar away from the bar head to
put some tension on the saw chain.
– With the screwdriver, tighten the chain tension
adjuster screw clockwise. Ensure the chain
and guide bar do not come apart while fitting.
– Also ensure the drive links have not separated
from the sprockets.
– Check the chain tension half way along the
guide bar by pulling the drive links out of the
groove. Continue tightening the chain tension
until only a complete drive link
is visible.
– Elevate the tip of the guide bar, keeping light
pressure down on the front of the power head
while tightening the clutch cover nuts fully.
– When secure, ensure the chain brake is
disengaged and check to see that the chain runs
freely in the guide bar groove.
– When operating a new saw chain, stop and
check the tension after a few minutes work
(with the engine stopped and blade brake
applied). This is necessary due to initial stretch
being taken up in the chain links.
– Warning: A loose saw chain is dangerous and
may result in a serious accident.
FIG.9
FIG.10
FIG.11
FIG.12
8 ASSEMBLY