8. ASSEMBLING THE ARC WELDER
13
8.1 FITTING THE CARRY/PULL HANDLE
– FIG. 1
– Place the handle
on top of the unit, as
indicated and fasten in place using the 2 bolts
supplied.
8.2 FITTING THE WHEELS – FIGS. 2 – 4
– Using one end of the wheel axle
, clip one of
the 4 spring clips
into the outer groove at the
end of the axle. Slide on one of the 4 wheel
washers
over the open end of the axle,
followed by one of the wheels
(making sure
that it is the correct way around as shown).
Follow this with a further wheel washer
and
further spring clip
– the first wheel should
now be securely on the end of the axle.
– Pass the opposite end of the axle through the
hole situated on the outer casing of the machine
, and out through the hole on the opposite
side of the unit
(fig.3).
– Thread the third spring clip into the inner groove
on the other end of the axle followed by the
third washer and the remaining wheel.
– Thread on the remaining washer and then fasten
the remaining spring clip into the outer groove.
– Snap-fit the 2 wheel caps
in place to
complete the wheel assembly.
FIG. 1
FIG. 3
FIG. 4
FIG. 2
