Draper 83591, Инструкции для

Страница: 8 / 24

8
5. HEALTH & SAFETY INFORMATION
10. Check damaged parts. Before further use of the tool, a guard or other part that is
damaged should be carefully checked to determine that it will operate properly and
perform its intended function. Check for alignment of moving parts, free running of
moving parts, breakage of parts, mounting and any other conditions that may affect its
operation. A guard or other part that is damaged should be properly repaired or
replaced by an authorised service centre unless otherwise indicated in this instruction
manual. Have defective switches replaced by an authorised service centre. Do not use the
tool if the switch does not turn it on and off.
11. Have your tool repaired by a qualified person. This electric tool is in accordance with the
relevant safety requirements. Repairs should only be carried out by qualified persons
using original spare parts, otherwise this may result in considerable danger to the user.
5.3 SAFETY RECOMMENDATIONS FOR THE CORRECT USE
OF ABRASIVE PRODUCTS
a. General. Bonded abrasive products are breakable and shall therefore be handled with
utmost care. The use of damaged or improperly mounted or used abrasive products is
dangerous and can cause serious injuries.
b. Delivery, handling and storage. Abrasive products shall be handled and transported with
care. Abrasive products shall be stored in such a manner that they are not subjected to
mechanical damaged and harmful environmental influences.
c. Selection of the abrasive product. Information on the label or the abrasive product as
well as restrictions of use, safety indications or any other instructions shall be followed.
In case of doubt concerning the selection of abrasive products, the user shall request
information from the manufacturer or supplier.
d. Visual inspection and ring test. Abrasive products shall be subjected to a visual inspection
as received before mounting. In addition, a ring test shall be executed for vitrified
wheels with D>80mm. Damaged abrasive products shall be destroyed.
e. Mounting before starting and information for grinding. The mounting of abrasive
products shall be carried out according to the instructions provided by both the wheel
and the machine manufacturer. Mounting of abrasive products shall be carried out by a
qualified trained person. Each time after mounting, the wheel shall be test run for a
reasonable time – the specified maximum operating speed of the wheel shall not be
exceeded.
f. Further information. The following instructions shall be observed, supplementary to the
information contained in the instruction for use of the grinding machine:
Observance of the user’s information from the grinding machine manufacturer.
Safety devices shall be mounting to the machine and shall be secured.
No grinding operations without protection by safety devices.
Use of personal protective equipment according to the type of machine and type of
application, e.g. eye and face protection, ear protection, respiratory protective devices,
protective footwear, protective gloves and other protective clothing.
Only grinding operations for which the abrasive product is suitable shall be carried out
(taking into account restrictions of use, safety indications or other information).
Jamming of the hand-held grinding machine shall be prevented. In the case of
cutting-off with hand-held grinding machines, the abrasive product shall be placed in the
cutting gap in a straight position.
Before placing the hand-held grinding machine on the workbench or on the floor it shall
be turned off and it shall be ensured that the abrasive product has stopped.