Draper 83591, Инструкции для

Страница: 14 / 24

14
8. PREPARING THE GRINDER
A. Type 27: Depressed Centre Grinding Wheel
B. Type 41: Flat Cutting-off Wheel
C. Type 42: Depressed Centre Cutting-off Wheel
D. Superabrasive Wheel (Diamond/CBN Abrasive)
E
A B C D
GRINDER SPINDLE
(M14)
E. Wire Cup Brush
FIG.4
IMPORTANT
NOTICE
- NOTE: Remove the plug from the socket
before carrying out adjustment, servicing or
maintenance.
- WARNING:
Prior to mounting an abrasive wheel ensure
the expiry date has not exceeded rendering
it potentially hazardous.
- WARNING:
Selection of the correct accessory, suitable
for the intended application is vital. Seek
guidance if uncertain of selection.
- WARNING:
The rated (no load) revolutions per minute
of the tool must not exceed the speed
capacity of the accessory. Please refer to the
accessory manufacturers instructions for
information.
- VISUAL INSPECTION:
Prior to fitting, abrasive/superabrasive
wheels shall be subject to a visual inspection.
- INSPECTION:
Each time after mounting, the
abrasive/superabrasive wheel shall be test
run for a reasonable time.
The specified maximum operating speed of
the wheel shall not be exceeded.
Damaged abrasives shall be destroyed.
Always wear approved safety goggles.
- B, C, D (FIG.3):
For cutting applications, and to comply to
current legislation, it is necessary to replace
the “grinding” guard supplied with this
machine with a “cutting” guard.
The appropriate “cutting” guard is available
from Draper Tools and must be fitted for
your safety.
IMPORTANT
NOTICE
8.3 FITTING/REPLACING ACCESSORIES (NOT SUPPLIED) – FIG. 4