9. ASSEMBLING THE STUD WELDER
9.4 WELDING
GUN
Electrode
holder
Trigger
9.5 SINGLE-SIDED
APPLICATIONS
Carbon rod shrinking
Washer welding
Stud welding
Wave form wire
welding
Pulling spot hammer
Hook for pulling on
washers/wave form
wire.
- 13 -
10.2 WASHER
WELDING
1. Connect earth wire to a clean, paint-free location on
metal workpiece,as close to welding area as
possible.
2. Connect washer adaptor with welding gun and
tighten, install washer.
3. Set correct amperage.
4. Set correct time.
5. Approximately a 90° angle to the dent. Put on
pressure and press trigger.
6. Remove welding gun. Hook the washer with pull
hammer. Slide the hammer to opposite direction to
pull out the dent.
1. Setting amperage too high or time too long can cause workpiece surface (vehicle body)
damage. Please weld other workpieces for practice before actual operations. Each panel may
require different settings.
2. Setting correct amperage and time according to the workpiece thickness.
3. Continuing another operation is available after this procedure finished. if not, please shut off
the main power supply and switch off the unit.
- 16 -
10. STUD WELDER INSTRUCTION
