6. TECHNICAL
DESCRIPTION
6.1 IDENTIFICATION
Time
decrease
LCD
display
Time
increase
Current
decrease
Current
increase
Function selection UP/DOWN
Gun testing button
Trigger control cable
Gun
cable
Earth cable
- 10 -
- 19 -
10.5
WRIGGLE FORM WIRE WELDING
1. Connect earth wire to a clean, paint-free location on
metal workpiece, as close to welding area as
possible.
2. Connect wriggle wire electrode tip with welding gun.
3. Set correct amperage
4. Set correct time.
5. Place a wave form wire horizontally on the dent.
Approximately a 90° angle to wave form wire. Put on
pressure and press trigger.
6. Connect hook puller with pull hammer. Hook wave
form wire and slide the hammer to pull out the dent.
1. Setting amperage too high or time too long can cause workpiece surface (vehicle body)
damage. Please weld other workpieces for practice before actual operations.
2. Setting correct amperage and time according to the workpiece thickness.
3. Continuing another operation is available after this procedure finished. If not, please shut off
the main power supply and switch off the unit.
10. STUD WELDER INSTRUCTION
