14
9.1 INSTALLING AND REMOVING
SOCKETS – FIGS. 4 – 5
This wrench is supplied with a ½" Square Drive
.
Note:
Never use any sockets or accessories that are not
hardened for impact use.
To fit a socket:
–
Roughly align the hole in the impact socket
with the sprung loaded ball detent
located on
the square drive anvil
.
–
Push fit the socket over the anvil. The mechanism
holds the socket securely in place.
To remove a socket:
–
Pull the socket away from the anvil to remove.
Note:
Extra effort may be required when fitting and
removing brand new sockets on their initial useage.
FIG.5
FIG.4
FIG.6
9. BASIC OPERATION
9.2 ROTATIONAL DRIVE SELECTION – FIG. 6
The forward/reverse drive selector switch
determines
the direction of rotation of the drive, i.e. clockwise or
anticlockwise.
To alter the direction of rotation:
–
Stop the machine and push switch
to the left or
right.
–
When the direction switch is pushed to the left, the
drive will rotate clockwise.
–
When the switch is pushed to the right, the drive will
rotate anticlockwise.
–
Before operation, check that the switch is set in the
required position. Do not change the direction of
rotation until the wrench comes to a complete stop.
–
When the wrench is not in use move the direction
switch to the neutral position (the middle setting) to
lock the trigger out.
Note:
Failure to use the neutral position may activate the
trigger inadvertently. This inadvertent operation may
cause the wrench to become damaged.
Содержание 01031
Страница 19: ...NOTES 19 ...
