9
5. HEALTH & SAFETY INFORMATION
8. Switch the charger on and check that the correct indicators illuminate, allow the battery
pack to charge (see the specific instructions for your charger). Once charging is complete,
switch the charger off, remove the battery pack and store, repeat the procedure if you
have more than one battery to charge. Note that some RAPID chargers require a "rest"
period between charges, read the instruction manual concerning your specific charger to
see if this is the case. After charging is complete, unplug the charger from the socket
outlet by pulling on the plug. Do not pull on the cable. Store the charger in a dry secure
place.
9. If, when the charger was switched on, the correct indications did not occur, leave for two
or three minutes to allow the charger to stabilise; if the correct indications occur, allow
the charging cycle to proceed as normal. If no indication appears at all, switch off,
remove the battery pack, unplug the charger, check that the charger contacts and the
battery contacts are clean and repeat the process; if there is still no indication, switch off,
remove the battery pack, unplug the charger and check the fuse. If the fuse is blown,
replace and repeat the process; if the fuse blows again, or if the fuse was intact, attempt
no further action. Refer the charger to a suitably qualified person for assessment/repair.
10. Before charging the battery, read the instructions.
11. Batteries are for indoor use. Do not expose to rain.
12. Only charge Draper battery (83079) in its designated charger (83077).
13. Do not charge any other batteries in the charger. Any other application is considered
misuse.
14. The battery must be removed from the appliance before it is recycled.
15. The charger must be disconnected from the supply mains when removing the battery.
16. The battery must be disposed of in-line with local authority procedures.
17. Do not use any batteries other than 83079 in this product.
18. Do not crush, open or burn the battery. Exposure to potentially harmful materials may
occur.
19. In case of fire use CO2 dry chemical extinguisher.
20. Do not expose to high temperatures >50°C. The battery may degrade at high
temperatures.
21. The battery must only be charged by Draper charger 83077.
5.5 CONNECTION TO THE POWER SUPPLY (CHARGER)
Make sure the power supply information on the machine’s rating plate are compatible with
the power supply you intend to connect it to.
This charger comes supplied with a UK standard 3 pin plug. It is designed for connection to a
domestic power supply rated at 230V AC.
This charger is Class II
†
and is designed for connection to a power supply matching that
detailed on the rating label and compatible with the plug fitted.
If an extension lead is required, use an approved and compatible lead rated for this
appliance. Follow all the instruction supplied with the extension lead.
†
Double insulated : This product requires no earth connection as supplementary insulation
is applied to the basic insulation to protect against electric shock in the event of failure of
the basic insulation.
This product requires no earth connection as supplementary insulation is applied to the basic
insulation to protect against electric shock in the event of failure of the basic insulation.
Apart from replacing the fuse in the plug, no other electrical work is recommended on this
impact wrench.
Содержание 01031
Страница 19: ...NOTES 19 ...
