12
TITRE
TITRE
TITRE
UNIT DESCRIPTION
UNIT DESCRIPTION
DV2A32 / DF2A32
Vacuum pipe
Audioprotek
muffler
2 motor booster head
24V plug
Cold water s
upply
2 motor unit
Porthole
O-ring
Audioprotek muffler
Porthole window
To outside vent
To outside ve
nt
Dust entry
Rubber hand
Power cord
Audioprotek muffler
Audioprotek muffler
Power cord
24V plug
Water disc
harge (D
ia: 3in / 7
.6cm)
25
TITRE
TITRE
TITRE
INSTALLING THE PIPING SYSTEM
INSTALLING THE PIPING SYSTEM
The following pages illustrate piping diagrams, typical installations and the parts that we recommend
for the optimum performance of your central vacuum system.
•
An air outlet leading to outside must always be installed on your unit. Make sure that the evacuated
air does not lead under a carport
.
• If your unit includes two motors, it is important to use metal piping and couplings for the air outlet.
• To determine where to locate the wall inlets, use the length of the vacuum hose as a basis, measuring
the furthest point from the wall where the wall inlets are to be installed. Do the same for all the wall
inlets until all areas of the house or building can be reached with the vacuum hose, by moving it from
one wall inlet to another;
don’t forget to install one in the garage or outside to vacuum your car
.
• If your walls are made of gypsum board,
never install a wall inlet in the center of the wall
. Drill the
holes for the wall inlets close to a wall stud or a door frame.
• Any screw length can be used if you install the piping as illustrated in
Figure A
.
• If you install the piping as illustrated in
Figure B
, make sure to position the small screw in the right place
to avoid that a longer screw goes through the piping.
• Always use a short elbow when connecting the wall inlets
(Figures A and B)
to prevent long objects (for
example, a pencil) that may have been vacuumed by mistake from blocking the piping further on.
GENERAL INFORMATION
Figure A
Figure B
Small Screw
Short elbow
