Dräger Vitalert 3000 Series, Руководство по установке и настройке

Страница: 7 / 40

Section 2
Setup and Installation
Overview
This section contains an equipment checklist along with all the steps
necessary for the installation and connection of the Vitalert 3000 Series
monitor and external sensors.
Equipment/
Accessory
Checklist
Remove the Vitalert 3000 Series monitoring system and accessories from
the container. Use the checklist below to make sure the following articles
were included in the container:
1 Vitalert 3000, 3100, 3200, or 3300 monitor
1 Power cable
1 Data cable (DB9/DB9)
1 Vitalert 3000 Series Operator’s Manual
Respiratory Accessories:
1 Gas sample line
1 Adapter/filter
1 Water trap reservoir
1 Six-foot exhaust hose
1 Scavenger adapter assembly
2 Air filters
Pulse Oximetry Accessories (models 3000, 3200)
1 Patient cable with pre-amp
1 Finger probe
Noninvasive Blood Pressure Accessories (models 3100, 3200)
1 Cuff extension hose
1 Adult cuff
Installing the
Vitalert 3000 Series
Monitor
Installing the Vitalert 3000 Series requires approximately 13.5 by 17 inches
of shelf space. The shelf should be capable of supporting at least 35
pounds.
NOTE: The Vitalert 3000 Series monitor is equipped with a universal
power supply for 100-240 VAC primary electrical power. The
supplied power cord comes with a 117 VAC hospital grade
plug. If a different plug is needed, an appropriate connector
must be installed on the cord by a qualified electrician.
Attach one end of the power cable to the receptacle on the rear panel. The
other end of the Vitalert 3000 Series power cable must be plugged into a
grounded outlet.
CAUTION: The Vitalert 3000 Series may have a leakage current of up to
50
µ A. When plugged into the convenience receptacle of
another device, the monitor may contribute up to 50 µ A to
the total system chassis leakage current of that device.
2-1
RETURN TO CD-ROM TABLE OF CONTENTS