Dräger RVP 5000, Техническое руководство, Страница: 36 / 40

36 Dräger RVP 5000
Faults, causes and remedy
15 Faults, causes and remedy
If you have any problems with the installation or faults occur
during operation, please refer to the Dräger service
department.
16 Maintenance
z
The Dräger RVP 5000 must be checked regularly (every 6
months is recommended) by a specialist.
z
Only allow specialists to perform repairs to the equipment.
z
Use only original Dräger parts for maintenance work.
z
Contact Dräger if you wish to take out service contract and
have any repairs carried out.
16.1 Changing the backup battery
1. Switch off the power sup-
ply.
2. Remove all connections
from the underneath of
the equipment.
3. Unscrew the screws on
the back and remove the
housing.
4. Remove old batteries
from the holder and insert
new ones (lithium type
CR2025).
5. Remount the housing
and reconnect.
6. Switch on the power
supply.
7. "Reset the date and time.
16.2 Changing the CompactFlash memory
card
The CompactFlash port is a type II port you can use with type
I or type II cards. Use 2 GB cards with the Dräger RVP 5000
CompactFlash. The CompactFlash memory card can be used
to record measured values and evaluations, as well as to
create and transfer large amounts of configuration data.
The CompactFlash memory card must be inserted or ejected
only when the equipment is switched off.
Information that is saved using a Dräger RVP 5000 on a
CompactFlash memory card can be evaluated using a card
reader that is connected to your PC. The information is saved
in FAT16 file format, which is IBM (Windows®) PC-compatible.
By exchanging a CompactFlash card Dräger recommends
only to use Sandisk and SimpleTech cards, as only these have
been tested by the manufacturer of the panel.
16.3 Disposing of electric and electronic
equipment
Since August 2005, EC-wide directives on the disposal
of electric and electronic equipment have applied.
These are stipulated in the EC guideline 2002/96/EC
and national laws and they apply to this equipment.
Special collecting and recycling options have been
established for households. As this equipment is not registered
for use in private households, it must not be disposed of in
such a manner. It can be returned to your national Dräger sales
organisation for disposal. Feel free to contact them with
queries concerning disposal.
DANGER
Risk of electric shock! The inverter board that is fixed
to the assembly plate supplies the high voltage that is
necessary to operate the background lighting.
Touching the inverter board could cause injury.
WARNING
Danger of explosion! Do not throw used batteries into
a fire and do not open them with force. Dispose of
batteries in accordance with the national guidelines.
NOTICE
The printed circuit board contains sensitive, electronic
components. After dismantling the rear cover and
before touching the operating interface first you have
to remove any static charge in your body by touching
an uninsulated, grounded metal object. Make sure you
handle the operating interface only at clean,
conductive work places. Furthermore, never touch the
surface of the printed circuit board. Dirt, grease or
other contaminants could have a negative effect on the
circuit.
03933194.eps
1
!
!
i i