20
Dräger HPS 7000
Use
3.2.4
Adjusting the mask pockets of the mask/helmet
adapter
1. Pull the locking pin out off
the mask pocket (1).
2. Pull the mask pocket back
(2) and remove it from the
lock.
3. Place the mask pocket at
the desired position in the
lock. The position must be
chosen carefully to ensure
the full mask fits tightly on
the face.
4. Insert the locking pin into the mask pocket.
3.2.5
Attaching the neck guard
z
Fasten the neck guard to
the 4 push buttons on the
inside of the neck guard
holder.
z
When a Holland cloth is used:
a. Mark the position of the hook-and-loop strips on the
support ring according to the Holland cloth. Position the
centre hook-and-loop strip in the recess on the front
side.
b. Attach the hook-and-loop strips to the support ring.
c. Close the Holland cloth at the front side and attach to
the hook-and-loop strip at the support ring.
3.2.6
Attaching reflective strip R 79 005
z
Glue reflective strip in
place as depicted.
3.2.7
Attaching the lamp holder
1. Loosen the screw and
remove the blind plugs
from the function plate.
2. Insert the lamp holder and
fasten with zigzag spring
and screw (torque:
1.1 Nm).
3.2.8
Attaching helmet lamp HPS 7000
1. Remove the face shield (see chapter 4.3.3 on page 23).
2. Remove the screw and
detach the front cover.
3. Make sure the
O-ring is undamaged.
Lubricate the O-ring with
Vaseline and insert into the
helmet shell.
4. Position the mounting plate of the helmet lamp onto the
helmet shell.
5. Tighten the screw (torque: 0.7 Nm).
6. Insert the helmet lamp into
the front of the helmet
lamp's mounting plate and
screw down in rear (torque:
0.25 Nm ±0.05 Nm).
7. If needed, attach the face
shield (see chapter
4.3.3
on page 23).
3.2.9
Fastening the face shield
z
Turn both CSA fasteners
so that they press against
the face shield.
This prevents the face
shield from moving.
NOTICE
The mask pockets can be used in 4 positions. Place
both mask pockets at the same position to ensure that
the full-face mask sits evenly on the face.
00621991.eps
1
2
i
i
00721991.eps
00321991.eps
NOTICE
The CSA fasteners are snapped into the helmet shell.
00421991.eps
00821991.eps
00921991.eps
00521991.eps
i
i
