DR PULSE 62V POLE SAW, Руководство по безопасности и эксплуатации

Страница: 5 / 24

CONTACT US AT
www.DRpower.com
5

Do not use your DR Pulse 62V Pole Saw for any job other than the intended use.

Avoid unintentional starting - do not carry the Saw with your finger on the ON/OFF Trigger.

Remove the Battery Pack when inspecting or cleaning material from the Saw.

Never pick up or hold the Saw by the cutting Chain.

Be aware that the cutting Chain coasts to a stop after releasing the ON/OFF Trigger; it does not stop immediately.

Do not operate the Pole Saw in gaseous or explosive environments, the Motor normally sparks, and the sparks might ignite
fumes.

Never over reach. Keep proper footing and balance at all times.

Do not operate the Saw in the rain, while in a tree, on a ladder or on a scaffold.

Never operate your Saw on a slippery, wet, muddy, or icy surface. Exercise caution to avoid slipping or falling.

Never stand under the limb that you are trimming. Position yourself out of the way of falling debris.

Operate only in daylight or in an area well lit by artificial light.

Stay alert and watch what you are doing. Do not operate the Pole Saw when you are tired or under the influence of medication,
drugs, or alcohol.
Operating Your Pole Saw Safely

Protect yourself from electrocution; maintain a minimum of 50ft (15m) from overhead electrical lines.

If the Saw jams on any electrical cord or line, DO NOT TOUCH THE BAR OR CHAIN, THEY CAN BECOME ELECTRICALLY
LIVE AND VERY DANGEROUS . Safely disconnect the damaged electrical cord or line from its power source. If in doubt, call
an electrician or an electrical contractor for assistance. Failure to heed this DANGER will result in death or serious personal
injury.

This Saw can sever body parts! Keep hands and feet away from the Chain and always keep both hands on the Pole.

Do not force the Pole Saw - it will do the job better and with less likelihood of a risk of injury when cutting at its own rate.

Use extreme caution when cutting small size brush, saplings or limbs under tension, because slender and tense material may
catch the Saw and be whipped toward you, or spring back, pulling you off balance. Do not cut small vines and/or small
underbrush.

If the Saw vibrates abnormally, stop the motor, remove the Battery, and inspect the tool for damage. Check for alignment of
moving parts, binding of moving parts, breakage of parts, mounting and any other condition that may affect its operation.
Repair the damage before restarting and operating the Pole Saw.
Note: Excessive vibration is generally a sign of trouble.

Do not operate the Pole Saw if it does not start normally or stop normally with the ON/OFF Trigger Switch.