DR PULSE 62V POLE SAW, Руководство по безопасности и эксплуатации

Страница: 24 / 24

8 0 0 H I N E S B U R G R O A D , S O U T H B U R L I N G T O N , V E R M O N T 0 5 4 0 3
©2019 DR Power Equipment. All rights reserved A0000215816_A
Always remove the Battery Pack before performing any maintenance, or repairs or inspection to your Pole Saw.

Remove the Battery Pack and allow the Saw to cool for at least five minutes before servicing or storing.

If you drop the Saw, carefully inspect it for damage. If the Battery is damaged, Bar is bent, Housing cracked, or Handle broken
or if you see any other condition that may affect the Saw's operation, visit our website at www.DRpower.com or call DR Power
Equipment Toll Free at: 1-800-DR-OWNER (376-9637) for assistance before putting it back into use.
Do not store the Battery Pack near children or pets, with metal objects that could short circuit the terminals, or close to a source
of heat, sparks, open flame or on the floor as it may be damp or subject to accidental flooding. In addition, never expose the
Battery Pack to abnormal shaking or shocks. Regularly observe the external appearance of the Battery Pack. Never use a Battery
Pack that shows cracks, changes shape, or obviously damaged.
Daily Checklist, Cleaning and Storing for your DR PULSE 62V POLE SAW
To help maintain your DR Pole Saw for optimum performance, we recommend you follow this checklist each time you use your
Saw.
[ ] BATTERY PACK: Make sure the Battery Pack has a full charge.
[ ] INSPECT: Before inserting the Battery Pack, inspect for any visible damage to the Chain, Bar, or Motor Housing. Inspect the
Oil Port, Bar Rails, and clean them to remove any debris.
Check the Chain tension and Chain Teeth for sharpness.
Check the Bar and Chain Oil level, fill with only new Chain Oil specifically formulated for pole saws.
[ ] NOISES: If you notice anything unusual, such as a vibration or odd sound, shut the Saw OFF immediately. Remove the
Battery Pack and check the Saw for any damage.
If you cannot find the cause of the problem or are uncertain what to do, then have the Saw inspected by a qualified repair shop
before using it or visit our website at www.DRpower.com.
Cleaning the Pole Saw
Use only mild soap and a damp cloth to clean the Saw. Never let any liquid get inside the Motor Housing and NEVER immerse
any part of the Saw Housing into a liquid.
Storing

Always store the Saw with a full Battery Pack charge.

Ensure that the plastic Bar Cover is in place when storing.

Do not store the Saw near chemicals, such as fertilizers, organic or other solvents. Do not expose brake fluids, gasoline,
petroleum-based products, penetrating oils, etc., to the plastic parts of the Saw. These products are often highly corrosive and
may cause permanent damage, weaken, or destroy the plastic to your Saw.

When not in use, your Pole Saw should be stored indoors in a dry and high or locked-up place, out of reach of children.

For superior Battery Pack performance, always store the Battery Pack and Charger in a DRY environment with temperatures
between 50ºF (10ºC) and +100ºF (+37.8ºC). Storing above +100 ºF can cause Battery Pack leakage, rust, or degradation of the
Battery Pack performance. The lower the storage temperature is within the specified range, the better. The Battery Pack will
discharge more slowly at low temperatures. Charge the Battery Pack for 75 minutes, until fully charged, prior to storage and
then every one to two months; and then again prior to the first seasons use. To prevent permanent damage to the Battery Pack,
never store it in a discharged condition. Be sure to remove the Battery Pack from the Charger after charging. In addition, you
can safely keep the Battery Pack in your tool when storing for the long term.