CONTACT US AT
www.DRpower.com
17
Tools and Supplies Needed:
File Holder
5/32" Round Chain File
Wire Brush
Depth Gauge jointer
Flat File
Safety Glasses
Gloves
Note:
Occasionally remove filing from the file with a wire brush.
1.
Position the File into a left-hand cutter with the holder and file at a 30° angle
to the Bar (
Figure 26 and 27
).
2.
Keep the file level with the top plate of the tooth and do not let the file dip
or rock.
3.
Use light but firm pressure to stroke towards the front corner of the tooth
and lift file away from the steel on the return stroke.
4.
Sharpen every left-hand tooth in the same direction.
5.
Move to the other side and file the right-hand cutters in the opposite
direction remembering to lift file away from the steel on each return stroke.
Note:
Every time the Chain is filed, check the Depth Gauge clearance with a Depth
Gauge Jointer. The depth gauge should be maintained at a clearance of .025
in. (0.6 mm) (
Figure 28
). Depth Gauge Jointers are available in .020 in. to
.035 in. (0.5 mm to 0.9 mm). Use a .025 in. (0.6 mm) Depth Gauge Jointer.
6.
Position the Depth Gauge Jointer (
Figure 29
) onto the top of the cutters,
with a Depth Gauge in the slot at the end of the jointer.
Note:
Depth Gauges on a Saw Chain are sometimes referred to as “Rakers”.
7.
If the Depth Gauge is above the Jointer, use a flat file to file it down to be as
close to level with top surface of the jointer without filing the Jointer.
Note:
Depth gauges must be adjusted with the flat file in the same direction the
adjoining cutter was filed with the round file. Use care not to contact cutter
face with the file when adjusting depth gauges.
8.
Check all remaining Depth Gauges with the Depth Gauge Jointer and file as
needed.
9.
After lowering each depth gauge, restore original shape by rounding the
front. Be careful not to damage adjoining drive links with the edge of the file
(
Figure 30
).
Figure 26
Figure 27
Figure 28
Figure 29
Figure 30
Содержание PULSE 62V POLE SAW
Страница 2: ...2 DR PULSE 62V POLE SAW ...
Страница 21: ...CONTACT US AT www DRpower com 21 Notes ...
Страница 23: ...contact us at www DRpower com 23 Schematic PULSE 62V POLE SAW ...
