Dr. Zanolli ASADOR G, Инструкция по установке, эксплуатации и обслуживанию

Страница: 26 / 32

8. MAINTENANCE
ASADOR 5G
– 10G – 15G – 20G – 30G – 40G
24
5. Unscrew (8) and change the jet (6) with one appropriate for the
dimentions for the type of gas (Tab. 3.1). The diameter of the jet is
shown on the its side. Do not forger to substitute the gasket with a new
one.
6. Follow these instructions in reverse order for reassembly.
7. Repeat the procedure for each burner.
8. Once this operation is finished, check that there are no leaks and close
the panel with its screws.
ATTENTION! After changing the gas supply it is necessary to
register the burner minimum and show the new gas type in use by
substituting the old gas type label with a new one.
Fig. 8.2
8.3.1 Regulating the
1. Remove the knob form the burner valve.
2. Introduce a screwdriver through the hole in the command panel
checking that it is the right type for adjusting the screw (1) (Fig. 8.3).