Dr. Zanolli ASADOR G, Инструкция по установке, эксплуатации и обслуживанию

Страница: 19 / 32

5. FUNCTIONING AND USE
ASADOR 5G
– 10G – 15G – 20G – 30G – 40G
17
5. FUNCTIONING AND USE
5.1 Preparing the rotisserie for use
If the rotisserie has just been installed or if it has lain idle for a
number of days, it needs to be completely cleaned as indicated in chapter
7 before using it for cooking. This is to eliminate residues left over from the
manufacturing process and the accumulation of dust or other substances
that could contaminate food products.
Before turning the oven on, ensure that glass surfaces are clean and
dry.
5.2 Turning on the spits and rotisserie
The switch activating the motor is located on the left side of the unit.
Apart from setting the spits in motion, this switch illuminates to show that
power is being supplied to the oven and that it is effectively turned on.
The knobs for opening the valves that control each burner are on the
right side of the rotisserie, corresponding to the position of each spit. To
light the gas, position a naked flame near to the burner and rotate the
knob in an anticlockwise direction by a ¼ of a turn (Max). To turn off put
the knob back to the zero position by turning it in a clockwise direction. To
reduce the temperature of the burner to a minimum turn the knob to the
minimum position.
5.3 Opening and closing the glass doors
The rotisseries ASADOR 5G,10G, 15G, 20G, 30G e 40G have two
vertically hinged doors made out of tempered glass which open on each
side. These doors are designed to protect the operator from the heat
released whilst the equipment is in use and to protect the food products
from being contaminated by external pollutants.
The glass door on the right side protrudes beyond the external
dimensions of the rotisserie(Fig. 4.1).
Avoid banging against the glass, this could cause it to immediately
fracture or it could break later without there being any apparent cause.