Dr. Trust ECG PEN, Инструкция пользователя

Страница: 6 / 13

Lightly press the electrode against your chest until you hear or feel a click.
Measurement
method B
chest”
(approximately corresponds to “lead 3”)
Top Electrodes
Place your lef wo upper electrodes on the
device and hold the device vertically in your hand.
5 cm
You can determine the correct position for placing the lower
electrode of the device against your chest using the following
methods:
• Draw an imaginary line from the front of your armpit downwards.
At the same time, draw an imaginary line going up 10 cm from the
lowest rib on the left side of your body. Place the lower electrode of
the device at the point where these two lines meet.
• Draw an imaginary line from the bottom of the centre of your chest
(sternum) to the left. At the same time, draw an imaginary line from
the front of your armpit downwards. Place the lower electrode of the
device at the point where these two lines meet.
Lightly press the electrode against your chest until you hear or feel a click.
Important: Do not exert excessive pressure on the electrodes with y
.
Important: Do not pr our skin.
Measurement
method C
“left hand–right hand”
(approximately corresponds to “lead 1”)
Place y wo upper electrodes on the device.
our left hand on the lower electrode.
Press the lower electrode until you hear or feel a click.
Important: Do not pr
our skin.
Please note that there must be no skin contact between your right and left hand (measurement
method C) or hand and chest (measurement methods A/B). Otherwise, the measurement cannot be
taken correctly. Do not move during the measurement, do not speak and hold the device still.
Movements of any kind will falsify the measurements.
1. The device will start beeping (if the beep is enabled) and the number indicator
or a few seconds. This indicates that the measurement is about to begin.
2. The measurement is completed, and the results are displayed at the end of the
30-second countdown.
Note:
If the bottom electrode is removed within the space of three seconds after the measurement
starts, the measurement will be displayed as EE.
11 10